este es el de Ron, deje un espacio de 0,5cm correspondiente al outer shackle
Moderador: administrador
Dushy escribió:WILLYS MB 10 LEAF SPRINGS
Please see the pictures below of the 10 Leaf Spring that i purchased to use in replacing the damaged springs of my 8 Leaf Willys MB springs.
I have dismantled the 10 Leaf Spring to clean, remove rust and paitn with a primer etc
1. The Will spring Bands are clearly visible
2. All leaves are bevelled
3. Leaf ends are stright and not tapered
4. Spring Centre Bolt seems to be in bad shape.
I would be grateful for your valuable and expert comments
Cheers
Dushy
Jon escribió:I found if you pre bend them first it works the best.
Then fold over the tab with the indent which should locate into the dimple on the springs. if it doesn't align, then re-punch it so it does.
The rest is a matter of inserting the tab into the rectangular part and hammer it down
Keep the springs clamped while you're doing all this naturally...
Pics might explain it a bit better....so here's a few of mine I did on the MBT springs....
JR
Volver a Bantam BRC , Willys MA, Ford GP, Willys MB, Ford GPW, Informacion Tecnica
Usuarios navegando por este Foro: No hay usuarios registrados visitando el Foro y 15 invitados