Moderador: administrador
vladimirsinisi escribió:Por lo que se ve hay varios anchos de mallas, hay un topic en G503 que muestran como hacerla mediante la malla que muestra Fer.
Rod Rushton escribió:I had this problem when I was doing my GPW. I looked at all the sets on offer, and they were all different - and I thought rather expensive.
I made up my own from commercially available flat braided earth strap, the lengths culled from the "All American Wonder"page which lists them - but mostly, not all correct for various years. Also the cost of these kits were quite high.
I tinned the ends with solder and used 15mm copper water pipe, cut into suitable lengths, depending on the size of the holes to be drilled, and partially deformed them in the vice, enough to slip the soldered ends of the strap into. These were then flattened around and soldered onto the previously tinned ends, before drilling the requisite sized hole through.
The soldered end pieces prevent the braids from splaying out, are easy to drill and are solid enough to bolt down to make a good contact.
I then sourced star washers as required. I used plumbers flux in the greasy form, which I washed off the excess afterwards with petrol
With a little practice they were very easy to make and quite satisfying to produce. I used about 6' / 2 metres of earth strap and about 30"/ 80mm of copper pipe, and they cost about a third of the shop bought ones.
signsup escribió:Found this using that Google thing.
GPW Bond Strap details
SNL #1 & 2 Cowl to Hood (two)
Length ~4 inches, Ends ¾ x ¾ . Drilled for ¼ inch mounting.
Hardware.
4 x ¼ in Loch washer (Int/Ext);
4 x Lock washer, 4 x flat Washer ID ¼ OD ¾
SNL #3 Cylinder Head to Firewall
Length ~9 inches, Ends 1 x 1. Drilled for 7/16th and 5/16th inch mounting.
Hardware.
1 x 7/16th Loch washer (Ext);
1 x Head Stud Nut
1 x 5/16th Flat Washer
1 5/16th Lock Washer
SNL #4 Temp Gauge, Speedo, Emergency/Parking Brake to Firewall
Length ~8 inches, Ends ¾ x ¾ . Drilled for 5/16th inch mounting. Soldered at 2 inches and 3 ¾ inches. Clamp holes drilled
Hardware.
1 x ¼ inch Cable Clamp
1 x 3/16th inch cable clamp
Mounting hardware is 2 x 10‐24NC x ½ inch Round head Machine Screw, 2 x #10 lock washers, 2 x #10 flat washers, 2 x #10‐24NC Hex Nuts.
SNL #5 Fuel Line to Firewall
Length ~5 inches, One End ¾ x ¾, the other end is tinned . Drilled for 5/16th inch mounting. Clamp holes drilled at the tinned end.
Hardware.
1 x ¼ inch cable clamp
Mounting hardware is 1 x 10‐24NC x ½ inch Round head Machine Screw, 1 x #10 lock washer, 1 x #10 flat washer, 1 x #10‐24NC Hex Nut. 1
John Wilson wjohn@iinet
Volver a Bantam BRC , Willys MA, Ford GP, Willys MB, Ford GPW, Informacion Tecnica
Usuarios navegando por este Foro: No hay usuarios registrados visitando el Foro y 3 invitados