![Shocked :shock:](./images/smilies/icon_eek.gif)
Moderador: administrador
MB43 escribió:En realidad el asiento apoya en las dos patas delanteras y atrás en el pasarruedas , este chapón es solo para proteger el tanque no sostiene el asiento .
Saludos
iowa escribió:here is the hole in the back of my drivers seat
which is supposed to have a nut welded in there,
s.o., maybe bubba removed it out.
i'll have to weld another one in there.
does anyone have a good close up picture
of this set up?
iowa
Michael J. Boyle escribió:Dan, iowa and johhny,
Trying to currently upload pic of the area in question, as soon as I can I will add the pic.
OK--Johnny--The bolt is a 5/16 x 24 NF x 1 1/8, metal to metal contact, passenger seat is not bolted to wheel well, it is held only by the two bolts in the front at the pivot point( yes, that means the seat could technically fly front on a sudden stop). Dont know if there is a diffence between willys and gpw seats in construction detail of this attachment point.
This is not a very good pic for detail, but the bump you see on the horizontal tube is the T-nut(?) that is welded on the backside of the tube for securing the drivers seat to the wheel well. As you can see I need to clean up the frame before repainting.
Jon escribió:Dan F escribió: just the stone guard and the bolt keep the weight of the driver off the tank.
No, the side of the wheel well and the one side of the frame of the seat support the position, on both sides...passenger and drivers. It's just the drivers that is bolted through.
That Bolt from the wheel well to the captive nut is:-
Bolt, Hex-Head, S, 5/16"-24NF-2, x 1-3/8"
See SNL G503 Section 1804 Seats
JR
m606paz escribió:Buena pregunta Vladimir...![]()
No se si hay plano de Jon Rodgers y con diferentes medidas..
Volver a Bantam BRC , Willys MA, Ford GP, Willys MB, Ford GPW, Informacion Tecnica
Usuarios navegando por este Foro: No hay usuarios registrados visitando el Foro y 9 invitados